22 - Troubleshooting
Fault Checklist
Problem
Cause
Drying takes too long.
- The laundry may be too wet.
- The laundry may have become tangled.
- The laundry may be too heavy.
- Clothes which dry quickly and clothes which dry slowly
may have been dried together.
- The ambient air temperature may be too low.
Items made of synthetic
fibres are charged with
static electricity after
drying.
- Reduce static electricity charges by adding fabric
conditioners to wash loads during the final rinse cycles.
A small item, for example,
a button, has dropped
through the filter frame
hole.
- Bring the item out by opening the panel in front of the
heat exchanger unit just the same as when cleaning
the fine filter.
The clogged filter warning
indicator is flashing
although none of the filters
are clogged.
- This is not a malfunction; the clogged filter warning
indicator flashes to alert users to clean the filters
after every 10
th
drying programme (twice a month).
The indicator may flash even if the filters have been
cleaned.
The displayed remaining
time changes.
- The remaining time is estimated and corrected
continually. Thus, the time displayed may change.
The operating sound
changes.
- This is normal; the change is caused by the on-off
conditions of the compressor and draining pump.
‘0’ display remains after the
programme has finished.
- This is not a malfunction; without the Anti-crease
function being set, the appliance automatically switches
itself off 2 hours after the programme finishes.
The lamp inside the drum
has gone out.
- The lamp lights up for 10 minutes when the door is
opened after the programme finishes. To activate the
lamp again, switch on the appliance, and then open the
door again.
The lamp inside the drum
does not light up.
- If 2 hours have elapsed after a programme is
completed, the lamp will not light up since the appliance
automatically switches itself off.
Drying has finished with
the Anti-crease set to OFF,
however, the Anti-crease
indicator is flashing.
- For safety, the dryer cools down inside the drum. The
Anti-crease indicator flashes during this time.
NH-P70G2_AUS_NZ.indb 22
2013/07/04 11:44:14
