22 - Troubleshooting
Fault Checklist
Problem
Cause
Appliance does not work.
- The fuse may have blown out or breaker may have
tripped.
- The mains plug may not be connected firmly to the
mains socket.
- The On button may have not been pressed.
- The Start button may have not been pressed.
- The door may not be closed properly.
Buttons do not work
- Settings cannot be changed while drying is in progress.
To change settings, switch the appliance off and on
again. Then, set the settings again.
- Child Lock may be activated. (See page 9.)
Drying repeatedly starts
and stops.
- This is not a malfunction; the drum slowly rotates and
stops repeatedly when the “Anti-crease” function has
been set.
Laundry is not sufficiently
dried. (Some portions are
damp.)
- The laundry might have been added to the drum during
drying.
- The laundry may have become tangled.
- The laundry may be too heavy.
- Try using the Warm Timed programme (Timed prog.
Warm) for small synthetic fibre loads, or dry them
together with large items of clothing.
- The moisture sensors may be dirty. (See page 19.)
Drying takes too long.
- The laundry may be too wet.
- The laundry may have become tangled.
- The laundry may be too heavy.
- Clothes which dry quickly and clothes which dry slowly
may have been dried together.
- The ambient air temperature may be too low.
Items made of synthetic
fibres are charged with
static electricity after
drying.
- Reduce static electricity charges by adding fabric
conditioners to wash loads during the final rinse cycles.
A small item, for example,
a button, has dropped
through the filter frame
hole.
- Bring the item out by opening the panel in front of the
heat exchanger unit just the same as when cleaning
the fine filter.
NH-P80S1_English.indb 22
2012/11/15 14:49:17
