7
Engl
ish
CAUTION
Do not repeatedly and quickly press the Power Shot Button.
– If repeating operation over an interval of less than 2 seconds, burns
due to hot water leaks may result.
If the shot intensity is low, do not operate the Power Shot Button.
– Doing so may cause burns due to hot water leaks.
Do not tilt or violently move the iron back and forth.
– Doing so may cause burns due to hot water leaks.
To reduce the risk of personal injury, property damage, electric shock or
fi re, please observe the following:
Use the dry iron on moist clothing (spray misted).
Test on an inconspicuous area when using with following fabric.
Or, place a cloth over the fabric to prevent marks on the fabric.
• Expensive or specially processed fabrics (velvet, acrylic, nylon,
cashmere, etc.)
• Fabrics that are labeled as “low heat” or “medium heat”, or dark colored
fabrics.
Disconnect the Power Plug by holding the wire instead of pulling on
the Power Cord.
– Failure to do so may break the wire, and may cause burns, electric
shock, or fi re due to a short circuit.
Care should be taken when using the iron.
– Steam emission may cause personal injury.
Drain water from the Water Tank after use.
– Failure to do so may cause the water to leak out from the Soleplate
when the iron is used next time.
NI-JWT980̲960̲Eng.indd 7
NI-JWT980̲960̲Eng.indd 7
2015/11/09 14:39:05
2015/11/09 14:39:05
