Panasonic NN-SF574S Operating Instruction And Cook Book Download

Page: 42 / 63

– 40 –

Meat

For best results, select roasts that are uniform in
shape.
Place meat on a microwave rack in a suitable dish.
Beef rib roast should be placed cut-side down.
Other bone-in roasts should be placed fat-side
down. Boneless roasts should be placed fat-side
up. Halfway through cooking, turn roasts. Half hams
should be shielded by wrapping an 8 cm wide strip
of foil around the large end of the ham. Secure to the
body of the ham with wooden toothpicks. Fold 3 cm
over cut surface. For shank ham halves, shield shank
bone by cupping it with foil. One third of the way
through cooking, remove ham from oven and cut off
skin. Turn fat side up and reshield edges. If desired,
glaze last 10 to 20 minutes of cooking. Loosely cover
baking dish with wax paper or paper towel to prevent
splatter. If a large amount of juice accumulates in
the bottom of the dish, drain occasionally. If desired,
reserve for making gravy. Multiply the weight of the
roast by the minimum recommended times per 500g.
Programme Micro Power and Time.
Meats can be shielded at the beginning of cooking or
halfway through cooking. If you wish to shield at the

Cooking Tender Cuts of Meat using Micro Power

Cooking Less-Tender Cuts of Meat by Micro Power

beginning of cooking, remove foil halfway through
the cooking time. Beef and pork rib roasts should be
shielded around the bones. Foil should extend about
5 cm down from bones. The shank and thin ends of
boneless roasts should also be shielded. Make sure
foil does not touch the sides of the oven, as arcing
may occur. Canned hams should be shielded on the
top cut-edge with a 3 cm strip of foil. Wrap strip of foil
around ham and secure to body of ham with wooden
toothpicks. Fold 2 cm over cut surface. After heating,
check temperature using a meat thermometer. The
thermometer should not touch bone or fat. If it does,
the reading could be inaccurate. Lower temperatures
are found in the centre of the roast and in the
muscle close to a large bone, such as a pork loin
centre rib roast. If the temperatures are low, return
meat to the oven and cook a few more minutes at
the recommended power level. DO NOT USE A
CONVENTIONAL MEAT THERMOMETER IN THE
MICROWAVE OVEN. Let stand, covered with foil,
10 to 15 minutes. During standing time the internal
temperature equalises and the temperature rises
5 °C to 10 °C.

Less-tender cuts of meat such as pot roasts should
be cooked in liquid. Use ½ to 2 cups of soup, broth,
etc. per 500

of meat. Use an oven cooking bag or

covered casserole when cooking less-tender cuts
of meat. Select a covered casserole deep enough
so that the meat does not touch the lid. If an oven
cooking bag is used, prepare the bag according to
package directions. Do not use wire or metal twist-

ties. Use the nylon tie provided, otherwise, use a
piece of cotton string or a strip cut from the open end
of the bag. Make six 2 cm slits in top of bag to allow
steam to escape. Multiply the weight of the roast by
the minimum recommended minutes per 500

suggested in the chart below. Programme Power and
Time. Turn meat over halfway through cooking. Meat
should be tender when cooked.

Meat Chart for Microwave Cooking

MEAT

POWER

APPROX. COOKING TIME

(minutes per 500

)

Beef

Roasts Medium

Rare
Medium
Well
Pot Roast

Medium
Medium
Medium

Med-Low