27
Problem
Possible Causes
What To Do
Technical
problems
Dishwasher
does not
start
Fuse blown, or the circuit
breaker may have tripped.
Replace fuse or reset circuit breaker. Remove any
other appliances sharing the same circuit with the
Dishwasher.
Power supply is not turned
ON.
Make sure the Dishwasher is turned ON and the door
is closed securely.
Make sure the power cord is properly plugged into the
wall socket.
Water pressure is low.
Check that the water supply is connected properly and
the water is turned ON.
Door of Dishwasher not
properly closed.
Make sure to close the door properly and latch it.
Water not
pumped from
Dishwasher
Twist in Drain Hose.
Check the Drain Hose.
Filter clogged.
Check the Coarse Filter.
(See section titled “Cleaning the Filter”).
Kitchen sink clogged.
Check the kitchen sink to make sure it is draining well.
If the problem is the kitchen sink not draining, a
plumber may be needed rather than a serviceman for
Dishwashers.
General
problems
Suds in the
tub
Improper detergent.
Use only the special Dishwasher detergent to avoid
suds. If this occurs, open the Dishwasher and let suds
evaporate.
Add approx 4.5 litres of cold water to the tub. Close
and latch the Dishwasher, then select any cycle.
Dishwasher will drain out the water at the fi rst step.
Open the door after draining is stopped and check if
the suds is disappeared.
Repeat if necessary.
Spilled rinse-aid.
Always wipe up rinse-aid spills immediately.
Stained tub
interior
Detergent with colourant
was used.
Make sure that the detergent is the one without
colourant.
White fi lm
on inside
surface
Minerals from water was
formed.
To clean the interior, use a damp sponge with
Dishwasher detergent and wear rubber gloves.
Never use any other cleaner than Dishwasher
detergent for the risk of foaming or suds.
Water supply
indicator light
up
Water pressure is low.
Check that the water supply is connected properly and
the water is turned ON. Check the inlet fi lter. If the inlet
fi lter is clogged, clean it with a toothbrush in running
water.
Water supply being
blocked by frozen water.
Wrap warm towels around the joints of the Inlet Hose.
Disconnect the Inlet Hose, and soak them in warm
water (50 °C or lower)
Noise
Knocking
noise in the
wash cabinet
A spray arm is knocking
against an item in a
basket.
Interrupt the programme, and rearrange the items
which are obstructing the spray arm.
Rattling
noise in the
wash cabinet
Items of crockery are loose
in the wash cabinet.
Interrupt the programme, and rearrange the items of
crockery.
Noise in the
Inlet Hose
and Drain
Hose
This may be caused by
on-site installation or the
cross-section of the piping.
This has no infl uence on the Dishwasher function.
If in doubt, contact a suitably qualifi ed plumber.
Troubleshooting
