Appendix
Once every 3 months
Pan water evap (Backside of the refrigerator)
Removing
1
Tilt up the pan water
evap a bit and then lift
it upward until the pan
water evap hole
unlocks from the hook
pan water evap.
1
1
2
2
2
Pull the pan water evap until it touches
with the evap pipe then carefully take it
out under the evap pipe.
Attaching
1
Insert the pan water evap under the evap
pipe.
2
Insert the pan water evap hole into the
hook pan water evap as well as press-
fitting both sides.
1
1
2
2
2
2
Requests
●
Do not damage or deform the evap pipe.
Troubleshooting
In these cases?
Check here.
The refrigerator does not
operate.
●
Check that the plug and wall socket are in good condition.
●
Check if there is any problem with the mains fuse or house wiring.
●
Check by unplugging for 10 minutes and plugging back in.
The refrigerator does not
cool enough.
●
Check to be sure that light in control panel is display at proper
positon (P.6)
●
Check to ensure that the refrigerator is not overloaded with
foodstuffs or that hot food have been placed in the refrigerator.
●
Is the refrigerator exposed to direct sunlight or a heat source?
●
Is the refrigerator door completely closed?
●
Is the refrigerator door opened frequently?
Vapor generated inside and
outside the cabinet / surface
of door.
●
Condensation may appear on the surface of the cabinet when
humidity is high or air circulation around the unit is poor.
●
If there is condensation inside, check if the door is completely closed.
Is the refrigerator frequently opened or left open for a long time?
Have any hot foodstuffs been placed inside the refrigerator?
The refrigerator generates
noise.
●
Check if the refrigerator is located on a stable, level
fl
oor and is
installed correctly.
Use the adjustable bolt if required to level the refrigerator. (P.4)
●
Check if there is any object in contact with the refrigerator.
●
Cracking sound within caused by the parts adjusting temperature
which is normal.
Food becomes frozen
●
Was the food placed near the cold air duct?
●
If the temperature control has been set to “Max” try adjusting the
temperature control to the “Min” setting.
●
Has the food been placed in the chilled case?
Hook pan water evap
Evap pipe
15
NR-BD468(EN).indd 15
NR-BD468(EN).indd 15
12/15/16 4:39 PM
12/15/16 4:39 PM
