Installation
4
Installation
Is the refrigerator installed in the
following locations?
●
Locations subject to
heat and direct sunlight
(The cooling power
will be reduced and
electricity wasted.)
●
Poorly ventilated
locations with high
humidity (Rust will be
caused.)
●
Locations where the
surface is unstable and
slanted
Æ
On carpet, mats, or vinyl
fl
oors, place
a plate underneath the refrigerator.
●
Locations not allowing the power plug to
be cleaned easily
(Dust accumulated may cause a
fi
re.)
Has a heat radiating space been
provided around the refrigerator?
Do not open/close the doors during the
interior cooling process.
Do not open/close the
doors until the interior has
cooled down suf
fi
ciently.
(Warm air
fl
owing into the
interior will block the cooling
function.)
Please wait until the interior has cooled
down.
●
It may take approximately four hours to
cool down the interior.
●
It may take 24 hours or more to cool
down the interior and achieve equilibrium
in the summer, etc.
●
Ice-making starts only after the interior
has been cooled down suf
fi
ciently.
Fix the refrigerator.
Turn the adjuster
bolts (right and left)
until they reach the
fl
oor to stabilize
the refrigerator.
For safety, the grounding connection should be done
(For a refrigerator with plug (2-pin plug) without any grounding wire)
The grounding connection will allow prevention of danger resulted from electricity leakage.
The grounding connection can be performed in 2 ways as follows:
●
In the case that the grounding receptacle has been prepared for the socket (plug
socket), connect the grounding wire to the screw used for
grounding connection at the bottom rear of the refrigerator
(regarding the screw used for grounding connection, please
notice the
symbol) as shown in the illustration
1
.
●
In the case that the socket (plug socket) has not been
provided with any grounding receptacle, connect the
grounding wire to the screw at the bottom of the refrigerator,
(as regard to the screw used for grounding connection,
please notice the
symbol). And then connect the other end
to the grounding rod as shown in the illustration
2
.
Prohibited spots for grounding connection
●
Water supply pipes and gas pipes (dangers from electric
shock or explosion).
●
The grounding wires of telephone cords and lightning rods (dangers from lightning).
1
2
5 cm or more
both left and right
10 cm or more
at the back of
the refrigerator
30 cm or more
above the
refrigerator
NR-BD468(EN).indd 4
NR-BD468(EN).indd 4
12/15/16 4:39 PM
12/15/16 4:39 PM
