Removing
1. Tilt up the evap pan
a bit and then lift it
upward until the evap
pan hole unlock from
the hook evap pan.
2. Pull the evap pan until
touching with evap pipe
and carefully take it out
under the evap pipe.
Attaching
1. Insert the evap pan under the evap pipe.
2. Insert the evap pan hole into the hook
evap pan as well as press-fitting both
sides.
Removing the evap pan for cleaning.
Note: Please do not deform the evap pipe.
Evap pipe
Hook evap pan
Evap pipe
Vapor generated
inside and outside
the cabinet / surface
of door.
●
Condensation may appear on the surface of cabinet when humidity is high,
e.g. during rainy season or the air circulation is not good.
●
If there is condensation inside, check if the door is completely closed.
Is the refrigerator frequently opened or left open for a long time?
Is there any hot foodstuff refrigerated inside?
The refrigerator
does not operate.
●
Check that the plug and its socket are in good condition.
●
Check if there is any problem on main fuse and electrical system of the house.
●
Check by unplug and wait for 5 minutes before plugging it back in.
The refrigerator
does not cool
enough.
●
Check to be sure that the temperature control button is at the proper position.
●
Check to see if the refrigerator is overloaded with stuff or there is any hot
foodstuff refrigerated inside.
●
Is the refrigerator exposed directly to sunlight or heat source?
●
Is the refrigerator door completely closed?
●
Is the refrigerator door opened frequently?
The refrigerator
generates noise.
●
Check if the refrigerator is located on a stable floor or is installed properly.
●
Check if there is any object in contact with the refrigerator.
●
Cracking sound within caused by the parts adjusting temperature which is normal.
LED lamp does not
turn on.
●
Please contact Panasonic service center.
●
Do you put the food near cold air duct?
●
Do you adjust the temperature control at “Max”? Should Adjust to “Med” or “Min”.
Food becomes frozen
11
Troubleshooting
AK-172190 NR-BR307-En_MA.indd 11
9/8/2557 BE 1:59 PM
