10
Installation
Installing the refrigerator
The refrigerator comes on four casters to enable it to be moved easily.
been decided upon, secure the refrigerator, and adjust it so that it is level.
Removing the front grille
When the two doors are opened and the front grille is viewed from above, two screws
– one on the left and the other on the right – will be seen.
Turn these screws counterclockwise, and remove them.
There is a connecting area slightly to the right of the centre of the front grille at the
bottom. Take hold of this area, and pull the grille toward you to remove it.
Securing the refrigerator
Insert a flat screwdriver into a slot on the adjustable legs at the left and right, turn
them in the direction shown by the arrows to lower the legs to the floor level, and then
secure the legs firmly.
Levelling the refrigerator
Turn the adjustable legs so that the refrigerator is installed flush with the floor.
If the left and right doors are not flush with each other, turn one of the adjustable legs, and bring the doors into alignment.
If the left door is lower than the right door
Insert a flat screwdriver into a slot on the adjustable leg on the
left, turn it in the direction shown by the arrow, and adjust.
If the right door is lower than the left door
Insert a flat screwdriver into a slot on the adjustable leg on the right,
turn it in the direction shown by the arrow, and adjust.
Attaching the front grille
Follow the steps for removing the grille in their reverse order.
●
Take care not to pinch or damage the water supply hose.
Front grille
Connecting area
Adjustable legs
Summary of Contents for NR-BS53VW3
Page 255: ......
