Trays
Door shelf
Vegetable case / Chilled case
Removing
1
. Unhook the protrusion at the back by lifting
it upward and pulling the tray outward until
removing.
Attaching
2
. Push the tray until it reached the end lock.
L
Removing and re-installing for cleaning.
Before cleaning or conducting maintenance, be absolutely sure to disconnect the power plug from
the power outlet. Do not connect or disconnect the power plug with wet hands.
When the plug is disconnected, leave it for 10 minutes before plugging again. If not, the compressor
may not work.
Removing
1
. Pull the case unit forward until it reaches the end of the stopper.
2
. Lift the front of the case unit slightly and remove completely.
Attaching
1
. Insert the case unit into the supports.
2
. Raise the case unit up slightly and push forward until the end is
reached.
Note
●
When removing the tray above the vegetable case,
please pull out the vegetable case
fi
rst and then
follow to removing the tray as above.
●
If the tray does not lock when attaching it, ensure
that it is the correct tray.
Note
●
To maintain vitamins in fruits and vegetables, please ensure
the drawer locks properly after use.
To Clean
Removing
1
. Lift it upward, alternating between the right and left side.
Attaching
2
. Place on both supports and then press in until it reaches the
end of supports.
Rail
Protrusion
13
NR-BY55BP, NR-BY55BV(EN)(AU).indd 13
NR-BY55BP, NR-BY55BV(EN)(AU).indd 13
6/30/2559 BE 10:14 AM
6/30/2559 BE 10:14 AM
