11
R E C
SAVE
1
2
3
1
PUSH
LOCK
EJECT
3
<
1
1
2
1
1
2
Lens Cap and Grip Belt
To protect the Lens surface, attach the Lens Cap. Adjust the length of the
Grip Belt to the size of your hand.
1
Attach the Lens Cap to the Grip Belt.
2
Put your hand through the Grip Belt and adjust the length.
≥
The removed Lens Cap can be hooked onto the Grip Belt
1
.(When you are
not recording, be sure to keep the Lens Cap attached to the Lens for
protection.)
~~~~~~~~~~~~~~~~~~~~~~~~~
Attaching the Shoulder Strap
We recommend that you attach the Shoulder Strap before going out of doors
to record so as to avoid dropping the Movie Camera.
1
Pull the end of the Shoulder Strap through the Shoulder
Strap Holder on the Movie Camera.
2
Fold the tip of the Shoulder Strap, run it through the
Shoulder Strap Length Adjuster, and pull it.
≥
Pull it out more than 2 cm
1
from the Shoulder Strap Length Adjuster
so that it cannot slip off.
~~~~~~~~~~~~~~~~~~~~~~~~~
Inserting a Cassette
When power is supplied to the Movie Camera, the Cassette can be taken out
without turning the Movie Camera [ON].
1
Slide the [
<
EJECT] Lever to open the Cover.
2
Insert a Cassette.
3
Close the Cover and press the [PUSH LOCK] Button to lock
the Cover.
ª
Accidental Erasure Prevention
Opening the accidental erasure prevention slider
1
on the cassette (by
sliding it in the [SAVE] arrow direction) prevents recording. To enable
recording, close the accidental erasure prevention slider (by sliding it in the
[REC] arrow direction).
≥
For other notes concerning this item, see page 39.
B.book 11 ページ ２００１年３月１４日 水曜日 午前１１時２１分
Summary of Contents for NV-DS27
Page 50: ...50 B book 50...
Page 51: ...51 B book 51...
