12
12:30:45
15.10.2001
12:30:45
15.10.2001
12:30:45
15.10.2001
12:30:45
15.10.2001
2
3
2
LCD/EVF SET
PRESS MENU TO RETURN
LCD BRIGHTNESS
[-]||||----[+]
LCD COLOUR LEVEL
[-]||||----[+]
EVF BRIGHTNESS
[-]||||----[+]
180
x
90
x
1
2
1
1
1
2
OPEN
OPEN
PUSH
1, 2
3
1
CAMERA
VCR
CARD P.B
MODE
MODE
ON
ON
OFF
OFF
Turning on the Movie Camera and Selecting
Modes
Turn on the power first and then select modes.
ª
How to Turn on the Power
1
Set the [OFF/ON/MODE] Switch to [ON] while pressing the
centre button
1
.
≥
The [CAMERA] Lamp lights up.
ª
How to Switch Modes
2
Slide the [OFF/ON/MODE] Switch.
≥
With each slide, the Mode changes.
≥
The appropriate Mode Lamp lights up.
ª
How to Turn off the Power
3
Set the [OFF/ON/MODE] Switch to [OFF] while pressing the
centre button
1
.
~~~~~~~~~~~~~~~~~~~~~~~~
Using the Viewfinder/LCD Monitor
ª
Using the Viewfinder
Before using the Viewfinder, adjust the field of view so that the displays inside
the Viewfinder become clear and easy to read.
1
Tilt the Viewfinder upward.
≥
The Viewfinder can also be pulled out for use.
≥
Do not pull on the Eyecup to extend the Viewfinder.
2
Adjust by sliding the Eyepiece Corrector Knob
1
.
ª
Using the LCD Monitor
With the LCD Monitor open, you can also record the picture while watching it.
1
1
1
1
Press the [PUSH OPEN] Button and, at the same time, bring
the LCD Monitor out about 90
o
in the direction of the arrow.
≥
The Viewfinder goes off.
2
2
2
2
Adjust the LCD Monitor angle according to the desired
recording angle.
≥
The LCD Monitor can rotate a maximum of 180
o
2
from the vertical
position to the upward direction and a maximum of 90
o
3
to the
downward direction. Forcefully rotating the LCD Monitor beyond these
ranges will damage the Movie Camera.
Closing the LCD Monitor
Push the LCD Monitor until the [PUSH OPEN] Button is securely locked.
ª
Adjusting Brightness and Colour Level
When [LCD/EVF SET] on the [DISPLAY SETUP] Sub-Menu is set to [YES],
the following items are displayed. (
l
LCD Brightness [LCD BRIGHTNESS]
It adjusts the brightness of the image on the LCD screen.
LCD Colour Level [LCD COLOUR LEVEL]
It adjusts the colour saturation of the image on the LCD screen.
Brightness of the Viewfinder [EVF BRIGHTNESS]
It adjusts the brightness of the image in the Viewfinder.
To Adjust
Press the [PUSH] Dial and select the item to be adjusted, and then turn the
[PUSH] Dial to raise or lower the number of vertical bars in the Bar Indication.
≥
A larger number of vertical bars indicates stronger brightness or colour
saturation.
Increasing the Brightness of the Entire LCD Monitor
Set the [LCD MODE] on the [DISPLAY SETUP] Sub-Menu to [BRIGHT].
≥
These adjustments do not affect the recorded images.
≥
For other notes concerning this item, see page 48.
A.book 12 ページ ２００１年７月２８日 土曜日 午前９時２７分
