Before Use
-9-
(88)
Clip
≥
Insert the plug securely into the [REMOTE]
Socket as far as it will goes. A loose
connection will spoil normal operation.
The Remote Controller
ª
Inserting a Button-type Battery
Before using the Remote Controller, insert the
supplied button-type battery.
1
While pressing the Stopper
1
, pull out the
Battery Holder.
2
Insert the button-type battery with the (
i
)
marking facing upward.
3
Insert the Battery Holder into the Remote
Controller.
≥
When the button-type battery is exhausted,
replace it with a new CR2025 battery. (A battery
is normally expected to last about 1 year.
However, it depends on operation frequency.)
≥
Make sure to match the poles correctly when
inserting the battery.
WARNING
“THE LITHIUM BATTERY IS A CRITICAL
COMPONENT (TYPE NUMBER CR2025
MANUFACTURED BY PANASONIC).
IT MUST NEVER BE SUBJECTED TO
EXCESSIVE HEAT OR DISCHARGE. IT
MUST THEREFORE ONLY BE FITTED IN
EQUIPMENT DESIGNED SPECIFICALLY
FOR ITS USE.
REPLACEMENT BATTERIES MUST BE OF
THE SAME TYPE AND MANUFACTURER.
THEY MUST BE FITTED IN THE SAME
MANNER AND LOCATION AS THE
ORIGINAL BATTERY, WITH THE
CORRECT POLARITY CONNECTIONS
OBSERVED.
DO NOT ATTEMPT TO RE-CHARGE THE
OLD BATTERY OR RE-USE IT FOR ANY
OTHER PURPOSE. IT SHOULD BE
DISPOSED OF IN WASTE PRODUCTS
DESTINED FOR BURIAL RATHER THAN
INCINERATION.”
1
ª
Using the Remote Controller
1
Direct the Remote Controller at the Remote
Control Sensor
(29)
of the Movie Camera
and press an appropriate button.
≥
Distance from the Movie Camera: Within
approximately 5 metres
≥
Angle: Within approximately 10
o
in the
upward, and 15
o
in the downward and
horizontal directions from the central axis
≥
The above operating ranges are for indoor use.
Outdoors or under strong light, the Movie
Camera may not operate properly even within
the above ranges.
≥
Within a 1-metre range, you can also use the
Remote Controller on the LCD Monitor side of
the Movie Camera.
Selecting Remote Controller Modes
When 2 Movie Cameras are used
simultaneously, they can be operated individually
by selecting different Remote Controller Modes.
≥
If the Remote Controller Mode of the Movie
Camera and that of the Remote Controller do
not match, [REMOTE] Indication is displayed.
Setup on the Movie Camera:
Set [REMOTE] on the [INITIAL] Sub-Menu to the
desired Remote Controller Mode. (
-17-
)
Setup on the Remote Controller:
[VCR1]:
Press the [
D
] Button and [
∫
] Button
simultaneously.
1
[VCR2]:
Press the [
E
] Button and [
∫
] Button
simultaneously.
2
≥
When the battery in the Remote Controller is
replaced, the mode is automatically reset to
[VCR1] Mode.
10˚
15˚
15˚
15˚
(29)
INDEX
INDEX
SELECT
STOP
K
L
∫
STILL ADV
T
W
PAUSE STILL ADV
6
1
5
;
E
D
P.B. ZOOM
2
1
120.200B.book 9 ページ ２００４年２月２５日 水曜日 午後４時０分
