Before using
6
VQT0T93
(37)
Shoulder strap fixture
≥
Put the strap through the fixture
1
and through
the stopper
2
so it will not come off. Extend
part
3
by at least 2 cm.
≥
Fit the other end of the belt similarly.
(38)
Lens hood
In order to remove the lens hood, rotate it
counterclockwise
1
. In order to fit it, put into slot
2
, and then rotate it clockwise.
≥
Fit the MC protector or the ND filter of the Filter
Kit (VW-LF37WE; optional) in front of the lens
hood. Do not fit the other accessories on the
hood. (Except for the lens cap)
≥
When fitting the tele conversion lens
(VW-LT3714ME; optional) or the wide
conversion lens (VW-LW3707M3E; optional),
first remove the lens hood.
≥
When 2 lens accessories, such as the ND filter
and tele conversion lens, are fitted and the
[W/T] lever is pressed toward the [W] side, the
4 corners of an image will be darkened.
(Vignetting)
Fitting the lens cap
Fit the lens cap to protect the surface of the lens.
If you do not use the movie camera when the MC
protector or the ND filter of the Filter Kit
(VW-LF37WE; optional) is attached to the front of
the lens hood, attach the lens cap to protect the
surface of the lens.
1
Run the end of the lens cap cord through
the hole in the grip belt attachment part and
run the lens cap through the lens cap cord.
≥
The lens cap removed can be hung on the lens
cap fixture.
≥
To fit or remove the lens cap, hold both sides of
the lens cap with the tips of your first 2 fingers.
(37)
3
2
1
1
2
(38)
VQT0T93ENG.book 6 ページ ２００５年１１月２８日 月曜日 午後９時６分
