Before using
19
VQT0T87
ª
Remote control usable range
≥
The distance between the remote control and
the camera: Within approx. 5 m
Angle: Approx. 10
o
up and 15
o
down, left, and
right
ª
Selecting the remote control mode
If 2 cameras are used simultaneously, set the
mode for one pair of movie camera and remote
control to [VCR1] and that of the other pair to
[VCR2]. This will prevent interference between
the 2 pairs. (The default setting is [VCR1]. When
the button-type battery is replaced, the setting will
revert to the default [VCR1].)
1
Setting on the camera:
Set [SETUP] >> [REMOTE] >> [VCR1] or
[VCR2].
2
Setting on the remote control:
[VCR1]:
Press [
D
] and [
∫
] simultaneously.
1
[VCR2]:
Press [
E
] and [
∫
] simultaneously.
2
ª
Concerning the button-type battery
≥
When the button-type battery runs down,
replace it with a new battery (part number:
CR2025). The battery is normally expected to
last about 1 year, but it depends on operation
frequency.
≥
Keep the button-type battery out of the reach of
children.
≥
If the remote control mode of the camera and
that of the remote control do not match with
each other, “REMOTE” will appear. When the
remote control is operated for the first time after
the camera is turned on, “CHECK REMOTE
MODE” (
-48-
) will appear and operation is
impossible. Set the same remote control mode.
≥
The remote control is intended for indoor
operation. Outdoors or under strong light, the
movie camera may not operate properly even
within the usable ranges.
≥
Within a 1 metre range, you can operate the
remote control from beside the remote control
sensor (LCD monitor side) of the movie camera.
2
1
GS180_EB.book 19 ページ ２００６年１２月２０日 水曜日 午後９時３９分
Summary of Contents for NV-GS230EB
Page 63: ...63 VQT0T87...
