11
VCR Auto Setup with RF cable
(Automatic tuning)
!
Turn on your television set.
!
With the
Stand-by/on switch
turn on the VCR. Automatic tuning for all
available TV stations begins. Approximate duration is 5 minutes.
!
After Automatic tuning has finished, press
EXIT
. The Owner ID screen will appear.
- While Auto Setup is running the first digit of the VCR display will flash. After a
while it will stop flashing and the RF output channel number will be displayed.
- Select an unused channel pre-set on your TV and tune it to the RF output
channel number shown on the VCR display (or until you can clearly see the
Auto Setup screen). Store the new video playback channel (refer to the
instructions for your TV).
VCR Display
You can complete the Owner ID now or skip this step and do it later. To do it
later, press the
EXIT
button. Your VCR is now ready to use.
!
To set the Owner ID now, press the
Numeric
buttons or
to enter a four-
digit PIN number.
!
Press , to correct the digit.
!
Make sure that you will remember the PIN number (make a note of it).
!
Press the
ENTER
button twice to confirm.
!
Enter the [Name], [House No] and [Postcode] in the same way.
!
Press the ENTER button to confirm each entry.
!
Press the
EXIT
button to leave the Owner ID screen.
!
You will now see the TV picture. Your VCR is now ready to use.
Owner ID
PIN number : ****
Name : **************
House No : ***********
Postcode : ***********
:
select
:
store
:
exit
ENTER
EXIT
You now have the opportunity
to enter your details and
help the police crack crime
see instruction book.
Owner ID
Datum / Zeit
Clock set
Time : 12 : 00 : 00
Date : 11. 6. 04
MANUAL
!
Press
to set the correct time and date.
!
Press the
ENTER
button to finish this setting.
If the clock setting menu appears
(Auto clock set was not possible due to a weak signal)
D
Mind that a wrong date or time will influence the programmed recording of TV
programmes (don't forget to change summer time and winter time).
D
In some cases, the RF output channel may interfere with the TV stations
transmitted in your area. This may prevent you from seeing the On-Screen
Display clearly. Please see page 18 for removing the interference before
restarting Auto Setup (page 33).
Auto Setup
:
exit
EXIT
Tuning : Ch 21
