PROCEDURES
FIP DISPLAY
Set the 3D DNR SW to ON, and
the S-VHS REC to ON in OSD
menu fuction. / Insert the S-
VHS BLANK TAPE. / Input the
Video sweep signal (See Fig.
E1) to AV3 (S-VIDEO IN) and
record it in SP and LP.
Press the FF and EJECT Keys
simultaneously for 3 seconds.
Press the FF and EJECT Keys
simultaneously twice.
Press the EJECT key for 3
seconds.
Press the CH UP and/or CH
DOWN key until "11" is
displayed on FIP.
Insert the Self-recorded tape
and playback it. (SP/LP mode)
Connect the Oscilloscope to:
*CH1....Video Out (TW3021).
*CH2....V.FREQ.(TW6002)
Press the "4" key on the remote controller.
(Confirm that TW6002 becomes high(2.5V)).
Adjust the Frequency response by pressing the
"2"(increase) and/or "8"(decrease) key on the
Remote Controller. (See Fig.E2)
Store the Adjusted value by pressing the "5" key
on the Remote Controller.
Release the Service mode by pressing the EJECT
and FF keys simultaneously in 6 times until the FIP
becomes normal indication.
Fig. E6
3.3.6. VHS VIDEO FREQUENCY RESPONSE ADJUSTMENT
19
Summary of Contents for NV-SV120EC
Page 24: ...10 2 CASING PARTS SECTION 24 ...
Page 25: ...10 3 PACKING PARTS SECTION 25 ...
Page 39: ...39 ...
Page 41: ...L7603 G0C270JA0019 CHOKE COIL AXIAL VLQ0599J270T 41 ...
