2. Removal of Color Picture Tube Unit
Place the Unit face down on a soft cloth before removing the Color
Picture Tube Unit.
3. Installation of Mechanism Chassis Ass’y and TV/VCR Main C.B.A.
When installing 2 Screws (449), slide the Holder Unit of the
Cassette Up Ass'y (Refer to "
WHEN LOADING WITHOUT A
CASSETTE
" in SERVICE NOTES) to tighten screws. Then, slide it
back to the EJECTPosition.
4. Removal of TV/VCR Main C.B.A.
When removing the P4002 Flat Cable from the Connector P4092 on
the AC Head, care must be taken to hold the Connector P4092
stable to avoid damaging it.
Otherwise, a satisfactory picture and secure precise tracking will
not be achieved. (Refer to "
TAPE INTERCHANGEABILITY
ADJUSTMENT
" in MECHANICAL ADJUSTMENT.)
Installation of TV/VCR Main C.B.A.
A. Make sure the Mode Select SW. on the TV/VCR Main C.B.A. is in
EJECT position. If not, rotate the Mode Select SW. until the
alignment projection is in the EJECT Position.
Fig. D7
26
Summary of Contents for Omnivision PV-C2542
