Hole with Hole A on Support Angle in EJECT mode. The each
mode Hole on Main Cam Gear should be a Through Hole with
Hole B on Support Angle in each mode.
Fig. J3-5
4. Main Cam Gear Kit
A. Main Cam Gear is supplied as a Main Cam Gear Kit only (Kit No.
VVGS0009).
Main Cam Gear Kit consists of a Main Cam Gear and a Main
Cam Push Nut.
However, Main Cam Push Nut is available separately as a
replacement part.
5. Installation of Main Cam Gear and Main Cam Push Nut
A. After installing the Support Angle, install the Main Cam Push
Nut with Needlenose Pliers etc. so that it is flush with the
chassis.
There may be some slight scratches on the Shaft of Main Cam
Gear, when removing the Main Cam Gear. In case that the Main
Cam Gear can be installed securely without tottering, it is fine to
use the one. If any tottering, install all new parts.
Fig. J3-6
6. The Main Cam Push Nut is not reusable. Install a new one.
6.2.6. Center Clutch Unit, Changing Gear Spring, Changing Gear, and Idler Arm
Unit
34
Summary of Contents for Omnivision PV-C2542
