With a PC
60
LSQT0974
To disconnect USB cable safely
If USB cable is disconnected while the computer
is on, error dialog box may appear. In such a case
click [OK] and close the dialog box. By following
the steps below you can disconnect the cable
safely.
1
Double click the
icon in task tray.
≥
Hardware disconnect dialog box appears.
2
Select [USB Mass Storage Device] and click
[Stop].
3
Verify [Matshita DVC USB Device] is
selected and click [OK].
≥
You can safely disconnect the cable.
Note on the driver name displayed
The driver name displayed will differ depending
on your OS, operating environment and the mode
of the Camcorder.
≥
Make sure Camcorder’s Card Access Lamp is
off and disconnect the cable. Also, the icon will
not be displayed when in Tape Recording Mode
or Tape Playback Mode.
If the above operation is not performed correctly,
when data is copied from the personal computer
to an SD Memory Card, the copied data may be
damaged.
When the following operations are performed, the
same results will occur as when the USB cable is
incorrectly removed (above). Therefore, it is
imperative that the above operation is completed
before proceeding.
≥
When SD Memory Card is removed.
≥
When Camcorder power is turned OFF.
≥
When Mode Dial is turned to change modes.
When using on Macintosh
Drag the [NO_NAME] or [Untitled] disk icon to the
[Trash], and then disconnect the USB connection
cable.
If you no longer need software or
driver (Uninstall)
The screens may vary with the type of OS.
1
Select [start] (>> [Settings]) >>
[Control Panel], select the software or the
driver from [Add/Remove Programs] to
uninstall.
≥
Uninstalling steps may vary depending on the
OS. Please refer to the user manual of your OS.
Notes
≥
Microsoft
®
and Windows
®
are either registered
trademarks or trademarks of Microsoft
Corporation in the United States and/or other
countries.
≥
Intel
®
and Pentium
®
are the registered
trademarks or trademarks of the Intel
Corporation.
≥
Apple, Mac OS, iMovie/iMovie HD, FireWire are
either registered trademarks or trademarks of
Apple Computer, Inc. in the United States and/
or other countries.
≥
All other names, company names, product
names, etc. in these instructions are the
trademarks or registered trademarks of their
respective corporations.
≥
Microsoft product screen shot(s) reprinted with
permission from Microsoft Corporation.
≥
The names of the products you are using may
differ from the names given in the text.
Depending on the operating environment and
other factors, the contents of the screens used
in these instructions may not necessarily match
what you will see on your screen.
CAUTION:
If you disconnect the USB cable while the
Card Access Lamp is on, it may damage the
Card data.
OFF
ON
PC
LSQT0974_ENG.book 60 ページ ２００５年１１月７日 月曜日 午前１１時５８分
