10
Precautions
Power cord
and Interactive
cable
C
Before moving the unit, disconnect the power cord from the electrical power
socket and AC inlet, and disconnect the interactive cable from the interactive
connector and a PC. Then coil them for transportation. Failure to do these cause
the cord and cable to be damaged if they are stepped on or if they catch on
something while the unit is being moved.
Replacing the
Thermal
transfer film
C
Dispose of the used thermal transfer film in a trash receptacle for burnable trash.
C
A negative of the copied image will remain on the thermal transfer film.
(To protect the security of your information, we recommend cutting up used
thermal transfer film with scissors or shredder before disposing of it.)
Electronic Pen
and
Electronic
Eraser
C
Do not cover the transmitter with your hand while using an interactive function as
this may cause the position of the Electronic Pen or the Electronic Eraser not to
be normally detected.
Transmitter
C
Press down firmly with the point of the Electronic Pen or the eraser cloth of the
Electronic Eraser on the screen film until you hear a buzzing sound, and then
move it slowly.
However, do not press down the point of the Electronic Pen too much strongly as
this may make a dent in the screen back panel.
C
Do not use two or more the Electronic Pens or the Electronic Eraser at the same
time as this may cause the position of the Electronic Pen or the Electronic Eraser
not to be normally detected.
C
For precise positioning, keep the Electronic Pen and Electronic Eraser
perpendicularly to the screen during use.
C
Since ultrasonic is used to detect the position of the Electronic Pen and Electronic
Eraser when they are being used, you may hear a buzzing sound, but this is not
harmful to the human body or peripheral hardware.
It will also not result in an electric shock.
NG
OK
Summary of Contents for Panaboard KX-BP800
Page 85: ...85 MEMO ...
