36
■
Adjusting the level of the screen
unit (Step 12–15: only for use of
the optional stand)
At the lowest level of the board attachment frame,
the printer cannot be installed. Raise the level of
the screen unit as follows.
• Please lock the casters when you adjustment the
screen height. Refer to Operating Instructions
page 5.
12
Loosen the height adjustment
handles on the board attachment
frame.
13
Hang the step frame on the center
of the reinforce pipe.
Hold the center of the board attachment
(lower) of the board attachment frame from
the back of the screen unit and lift the board
attachment frame by stepping on the step
frame to lift the board attachment frame
smoothly.
When lifting the board attachment frame, be
sure to hold the handle in the center of the
frame.
14
Hang the screen in the desired slots
of the slide plates and tighten the
handles.
Caution
The screen can be adjusted at 4 levels.
• The lowest level of the board attachment frame
is designed for the installation of the screen, so
the printer cannot be attached at that level. Use
the electronic board at upper 3 levels.
• Make sure to tighten the height adjustment
handles firmly after adjusting the level of the
screen.
• Confirm both of the screws are hung in the same
height slots.
• Store the step frame by hanging it on the board
attachment (upper).
Height
adjustment
handles
Height
adjustment
handles
Board
attachment
(lower)
Reinforce pipe
Step frame
Slot for installing
the screen
(The printer cannot
be attached at this
position.)
Slots for
height
adjustment
Step frame
UB-5310_MECA.book 36 ページ ２００３年５月１５日 木曜日 午後５時２３分
