Precautions
7
English
Operating Instructions
Installation
• Do not install the unit where it may be exposed to direct sunlight, near heating
equipment, or near air-conditioning vents as this may cause stretching and/or
discoloration of the screen.
• Do not install the unit in strong sunlight or strong lighting. Proper copying may
become impossible.
• Do not install the unit in locations where the temperature may change suddenly as
this may disable the unit’s ability to make copies.
Screen Film
• Make thick and dark lines inside the copying
area. Note that any writing inside the shaded
area (on right) cannot be copied.
• Do not allow writing to remain on the screen for
an extended period of time as it will become
harder to erase.
• Do not touch the screen, write with markers, or
erase while the screen is moving as this may result in damage to the unit.
• Do not erase with an overly dirty eraser (see page 21).
• Use a commercially available white board cleaner for hard-to-erase stains.
(SANFORD® EXPO® white board cleaner etc.)
• Do not attach chart paper to the screen film for copying as this may result in
damage to the unit.
Markers,
Erasers and
Copy Paper
• Use only the included or designated markers, erasers and copy paper.
(See page 25.)
Use of accessories other than those included or designated (such as oil-based
markers) may damage the screen or result in hard-to-erase markings.
• Store markers horizontally as vertical storage may stop the ink from coming out.
• Store a copy paper roll in a cool, dark, moisture free location.
• Do not store printed copies exposed to direct sunlight or high humidity, or inside
vinyl chloride (plastic) files.
• For long-term storage, make another copy with an ordinary paper copier machine.
Power Cord
• The included power cord is for use with this unit only. Do not use it with other
devices.
• When moving the unit, disconnect the power cord from the electrical power socket
and from the printer’s power connector and coil it for transportation as stepping on
the power cord or having it catch on something during movement may result in
damage to the cord.
USB Cable
• Use a shielded USB cable that is certified as logo by USB-IF.
• If you connect the electronic board to a USB hub, it is not guaranteed to work.
• Do not connect two or more Panasonic electronic boards to a computer. It may
cause the computer operation to become unstable.
Projector
• Light from the projector may enter the eye when using a projector to project images
for the purpose of making presentations and so on. Be very careful as direct
projector light may hurt the eyes.
35 mm
25 mm
25 mm
35 mm
Copying area
