Precautions
11
Before Y
ou S
tart
Precautions
Installation
•
Do not install the unit where it may be exposed to direct sunlight, near heating equipment, or
near air-conditioning vents as this may cause stretching and/or discoloration of the screen.
•
Do not install the unit in strong sunlight or strong lighting. Proper copying may become
impossible.
•
Do not install the unit in locations where the temperature may change suddenly as this may
disable the unit’s ability to make copies.
Screen Film
•
Make thick and dark lines inside the copying area.
Note that any writing inside the shaded area (on
right) cannot be copied.
•
Do not allow writing to remain on the screen for an
extended period of time as it will become harder to
erase.
•
Do not erase with an overly dirty eraser (see page
75).
•
Periodically wipe the screen film gently with a
water-dampened cloth that has been thoroughly wrung. (See page 75.)
•
Use a commercially available white board cleaner for hard-to-erase stains.
(SANFORD® EXPO® white board cleaner etc.)
•
Do not touch the screen, write with markers, or erase while the screen is moving as this may
result in damage to the unit.
•
Do not attach chart paper to the screen film for copying as this may result in damage to the
unit.
Markers,
Erasers and
Thermal
Transfer Film
•
Use only the included or designated markers, erasers and thermal transfer film. (See page
82.)
Use of accessories other than those included or designated (such as oil-based
markers) may damage the screen or result in hard-to-erase markings.
•
Copy quality increases with the thickness of the drawn line. To ensure quality copies, please
use the markers (big).
•
The markers for interactive (small) draw thin lines. The quality of the copies may be reduced
when these markers are used.
•
Do not store the thermal transfer film in a location subject to extreme changes in
temperature (such as near air conditioning or heating equipment) as this may cause
condensation on the thermal transfer film and result in poor print quality and/or paper jams.
•
Store markers horizontally as vertical storage may stop the ink from coming out.
•
The length of one roll of designated thermal transfer film (Replacement film: UG-6001) is
approximately 50 meters (164 ft.). One roll of thermal transfer film can make approximately
150 sheets of copies.
Note that the total number of copies may differ depending on the operating conditions.
Also note that the length of the thermal transfer film supplied with the unit is shorter
than the replacement film roll and is only approximately 10 meters (32.8 ft.).
Power Cord
and USB
Cable
•
When moving the unit, disconnect the power cord from the electrical power socket and from
the printer’s power connector, and disconnect the USB cable from the printer’s USB
connector and a computer. Then coil them for transportation as stepping on the power cord
and USB cable or having them catch on something during movement may result in damage
to the cord and cable.
•
If you connect the electronic board to a USB hub, it is not guaranteed to work.
•
Do not connect two or more Panasonic electronic boards to a computer. It may cause the
computer operation to become unstable.
25 mm (1
" )
35 mm
25 mm (1
" )
(1
3
/
8
" )
(1
3
/
8
" )
35 mm
Copying area
