223
5.7
Service Mode 7 (LBP Service Mode)
This test mode is used to change printer parameters and verify printer information.
Use the following procedure to change printer parameter.
Step
Operation or Unit Condition
LCD Display
1
Standby
2
Press “FUNCTION” and then “7”.
3
Press “MONITOR” four times, then press “
∗
”.
4
Press “7”.
5
Press “START” for printer parameter settings.
Press “2” and “START” to get the printer information.
Ex: Enter “START” for printer parameter settings.
6
Press “3” and “START”. Then enter the number of pages.
Ex: Enter “50” and “START”.
7
Repeat step 5 through 6 to request operation, or press “STOP” to return to
standby.
Sub-Code
Parameter Name
Description
1
1
Printer Counter
Displays and resets the printer and cassette(s) counters.
2
LBP Fuser Reset
Clears the LBP fuser error.
3
Out of Toner
Sets the number of pages to print after low toner is detected.
2
\//\
LBP ROM Version
Shows the LBP ROM Version.
\//\
LBP Print Available
Shows the remaining number of allowable printable pages after low
toner has been detected (Counter Only).
\//\
LBP MEMORY CAPACITY
Shows the page memory capacity.
SEP-12-1999 15:00
00%
SET MODE (1-6)
ENTER NO. OR
SERVICE MODE
ENTER NO. OR
1:LBP PARAMETER SET
LP SERVICE MODE (1-2)
1.PRINTER COUNTER
LBP PARAMETER SET
3.OUT OF TONER
LBP PARAMETER SET
SEP-12-1999 15:00
00%
Summary of Contents for Panafax DX-2000
