144
5.1.4.2.
Tonal Signal
This Service Mode is used to check the tonal signal output. Signals can be output to the line using the
following procedure.
Tonal Signal Table
Service Mode 4 - Tonal Signal
Step
Operation or Unit Condition
LCD Display
1
Standby
2
Press “FUNCTION” and then “7”.
3
Press “MONITOR” four times, then press “*”.
4
Press “4”.
5
Press “2” or
use “V” or “/\ “ to scroll to the desired Modem Test.
6
Press “START”.
7
Enter the signal number (1-7) to select the binary
signal.
8
Press "CLEAR" to end the signal generation. To select
another signal, repeat step 6.
9
Press "STOP" twice to return to standby.
Number
Signals
1
462 Hz
2
1080 Hz
3
1100 Hz
4
1300 Hz
5
1650 Hz
6
1850 Hz
7
2100 Hz
OCT-12 10:58 00%
SET MODE (1-8)
SERVICE MODE
SIGNAL TEST
TONAL TEST
IDLE (ENTER 1-7)
1080Hz
IDLE (ENTER 1-7)
OCT-12 10:58 00%
Summary of Contents for Panafax UF-490
