PanaVoice Courier Installation Manual 133
L
E A R N
N
E W
T
O N E
D
I A L O G
B
O X
The following options allow you to specify how a new tone will be learned:
Phone Number
Specifies the number to dial to generate the tone you want AccuCall Plus to learn.
The number can include digits (0 - 9, A - D, #) and dialing tokens, up to 50
characters in length.
Dialing Token Description
w
Waits for dial tone before dialing
, (comma)
Causes the dialing to pause for two seconds
*
Dials the standard R1 KP digit
T
Causes subsequent digits to be dialed as DTMF
M
Causes subsequent digits to be dialed as MF
Wait for Dial tone
Specifies whether to detect dial tone before proceeding to dial.
Minimum Cycles
Specifies the number of times Learn repeats the cadence analysis while learning the
tone.
Align Frequency
Specifies whether detected frequencies should be aligned with filters already defined
in the Filters window.
Scan High Frequency
Specifies whether to limit frequency analysis to 800 Hz and higher during Learn.
This type of frequency analysis is faster than scanning the full frequency range. Use
this option if Learn cannot define a tone because the cadence is too short for a
complete analysis.
Quick Scan
Quick scan performs frequency analysis twice as fast as normal scan, but is not as
accurate. Use this option if Learn cannot define a tone because the cadence is too
short for a complete analysis. Set Minimum Cycles to 0 to use this option.
L
E A R N I N G
… D
I A L O G
B
O X
This dialog box reports the progress of the current Learn New Tone operation.
The frequencies detected while learning are reported in the Frequency1 and Frequency2
fields. The cadences detected while learning are reported in the Cadence Detected
scroll box. Click the Stop button to abort the Learn New Tone operation and return to the
Learn New Tone dialog box.
After the Learn New Tone operation is complete, click the Add Tone button to add the
new Tone Definition to the current PCPM table, or click the Close button to discard the
results of the Learn New Tone operation. If you click Add Tone, the Edit Tone dialog is
displayed with the learned values. Enter a Tone Name and PCPM code, then click OK to
store the Tone Definition.
Summary of Contents for PanaVoice Courier
Page 15: ...PanaVoice Courier Installation Manual 14 TW O PO RT COURIER SC H EM AT IC...
Page 16: ...PanaVoice Courier Installation Manual 15 FO U R PO R T COURIER PLUS SCH EM AT I C...
Page 17: ...PanaVoice Courier Installation Manual 16 FO U R PO R T COURIER UMS SC H EM AT I C...
Page 80: ...PanaVoice Courier Installation Manual 79 COURIER QUICK REFERNCE CARD...
