17
PoE power supply is impossible.
Power is not supplied to a Powered Device.
If you use an STP cable, PoE power supply may not be possible depending on
the installation environment. In such cases, use a UTP cable.
Is a CAT5e or better straight cable (RJ45-8/8) used?
Is the cable connected to the port 1–12 that supports PoE power supply?
Ensure that either the port alone or the entire equipment is not overloaded.
Is the Powered Device connected to the port compliant with the IEEE802.3at
standard or IEEE802.3af standard?
Port LIM. LED is blinking in green:
Ensure that the total power supply demand from PoE-powered devices does
not exceed 112 W or 80 W.
If the supply power for the entire device is going to be used at 112 W or less,
use it in an area where it is 0 to 40°C.
If the supply power for the entire device is going to be used at 80 W or less,
use it in an area where it is 0 to 50°C.
When the power supply is suddenly shut off:
Confirm that a single port is not overloaded [Port LED (right) is not blinking in
Green], or that the power supply capacity for the device overall is not being
exceeded (PoE LIM. LED is not blinking in green).
* For the configuration and management methods, please see the
PDF version of the Operating Instructions on Panasonic’s website.
