100
4.6.7.h. LED Base Mode Configuration
On the System Security Configuration, pressing "B" opens the LED Base
Mode Configuration screen, as shown in Fig. 4-6-32. On this screen, you can
configure the LED base mode setting.
Fig. 4-6-32 LED Base Mode Configuration
Screen Description
System LED
base-mode
Shows the current LED base mode.
This is set to the status mode (Status) on shipment.
Status
Operating in status mode.
Eco
Operating in ECO mode.
Available commands are listed below.
B Change the LED base mode.
Press "B." The command prompt changes to "Select LED Base Mode (S/E)>." Press "S"
to change the LED base mode to the status mode. Press "E" to change it to the ECO
mode.
Q Return to the previous menu.
Note:
If the LED base mode is changed, the configuration information is
saved and all settings are stored in a built-in memory.
PN28160K Local Management System
System Security Configuration -> LED Base Mode Configuration
System LED base-mode: Status
Note: Save Configuration to Flash will be executed when LED Base Mode changed.
-------------------------------- <COMMAND> -----------------------------------
Set LED [B]ase Mode
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option
