73
4.6.3.o Set IPv6 Trap Receiver
On the SNMP Trap Receiver Configuration Menu, pressing "P" opens the Set
IPv6 Trap Receiver Menu, as shown in Fig. 4-6-20. On this screen, you can set
SNMP trap receiver.
Fig. 4-6-20 SNMP Trap Receiver Configuration (IPv6)
Screen Description
Trap Receiver
List:
Shows the current SNMP trap receiver settings.
No.
Shows the entry number on the SNMP trap receiver List.
IPv6 Address Shows the IPv6 address of the SNMP trap receiver.
Available commands are listed below.
I Set an IPv6 address for an SNMP trap receiver.
Press "I." The command prompt changes to "Enter manager entry number>." Enter
an SNMP trap receiver entry number you wish to configure. Then, the command
prompt changes to " Enter new receiver IPv6 address>." Enter an IPv6 address.
Q Return to the previous menu.
PN28160K Local Management System
SNMP Trap Receiver Configuration Menu -> Set IPv6 Trap Receiver Menu
Trap Receiver List:
No. IPv6 Address
----------------------------------------------
1 ::
2 ::
3 ::
4 ::
5 ::
6 ::
7 ::
8 ::
9 ::
10 ::
-------------------------------- <COMMAND> -----------------------------------
Set Receiver [I]Pv6 [Q]uit to previous menu
Command>
Enter the character in square brackets to select option
