149
<Command Entry Example>
An example of executing the command to show the link aggregation configuration is
shown below.
Fig. 4-2-1 Example of executing the command to show the link aggregation configuration
(1) Aggregation Group <1-8>
Shows the aggregation group ID.
(2) Status
Shows the aggregation group configuration status.
Static
Indicates that the aggregation link is statically registered.
(3) Criterion
Shows the traffic distribution type.
src-dst-mac Traffic
distribution is performed based on the destination MAC address
and the target MAC address of the transmitted frame.
(4) Admin Ports
Shows the list of ports set in the aggregation group.
(5) Oper Ports
Shows the list of ports currently belonging to the aggregation group.
Shows "(none)" if none of the Admin Ports are linked up.
M24eG> enable
M24eG# show aggregation-link group
Aggregation Group <1>
Status : Static
Criterion : src-dst-mac
Admin Ports : gi0/9-10
Oper Ports : gi0/9-10
Aggregation Group <2>
Status : Static
Criterion : src-dst-mac
Admin Ports : gi0/20-24
Oper Ports : (none)
M24eG#
(1)
(2)
(3)
(4)
(5)