16
<Command Entry Example>
An example of executing the command to show the address information is shown below.
Fig. 2-2 Example of executing the command to show the address information
(1) MAC Address
Shows the Switching Hub's MAC address.
(2) IP Address
Shows the Switching Hub's current IP address in operation.
(3) Subnet Mask
Shows the Switching Hub's current subnet mask in operation.
(4) Default Gateway
Shows the Switching Hub's current default gateway in operation.
M24eG> enable
M24eG# show ip conf
MAC Address : xx:xx:xx:xx:xx:xx
IP Address : 0.0.0.0
Subnet Mask : 0.0.0.0
Default Gateway : 0.0.0.0
M24eG#
(1)
(2)
(3)
(4)
(4)