160
<Command Entry Example>
An example of executing the command to show the access control is shown below.
Fig. 4-4-1 Classifier configuration display
(show AccessControl classifier all)
(1) Classifier Index
Shows the index number of the classifier.
(2) VLAN ID
Shows whether or not VLAN ID should be included in the target.
(3) 802.1p Priority
Shows whether or not IEEE 802.1p priority should be included in the target.
(4) DSCP
Shows whether or not DHCP should be included in the target.
(5) Protocol
Shows whether or not the protocol number should be included in the target.
(6) TCP SYN Flag
Shows whether or not TCP SYN flag should be included in the target.
(7) ICMP Type
Shows whether or not ICMP type should be included in the target.
(8) Source MAC Address
Shows whether or not the source MAC address should be included in the target.
(9) Source MAC Mask Length
Shows whether or not the mask length of the source MAC address should be included in
the target.
M24eG> enable
M24eG# show AccessControl classifier all
Classifier Index :1
VLAN ID :Ignore 802.1p Priority :Ignore DSCP :Ignore
Protocol :Ignore TCP SYN Flag :Ignore ICMP Type :Ignore
Source MAC Address :Ignore Source MAC Mask Length :Ignore
Destination MAC Adress :Ignore Destination MAC Mask Length :Ignore
Source IP Address :Ignore Source IP Mask Length :Ignore
Destination IP Address :Ignore Destination IP Mask Length :Ignore
Source Layer 4 Port :Ignore Destination Layer 4 port :Ignore
M24eG#
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(10)
(12)
(14)
(16)
(9)
(11)
(13)
(15)
(17)