195
<Command Entry Example>
An example of executing the command to show the storm control configuration is shown
below.
Fig. 4-7-1 Example of executing the command to show the storm control configuration
(1) Interface
Shows the interface for operating the storm control function.
(2) DLF/Broadcast/Multicast
Shows the status of storm control for unicast packets with unknown destination (Destination
Lookup Fail), broadcast packets, or multicast packets.
enabled
The storm control is enabled.
disabled
The storm control is disabled.
(3) Threshold
Shows the threshold value for the number of packets (Packet Per Second).
M24eG> enable
M24eG# show storm-control
Interface DLF Broadcast Multicast Threshold
--------- --------- --------- --------- ---------
1 disabled disabled disabled 0
2 disabled disabled disabled 0
3 disabled disabled disabled 0
4 disabled disabled disabled 0
5 disabled disabled disabled 0
6 disabled disabled disabled 0
7 disabled disabled disabled 0
8 disabled disabled disabled 0
9 disabled disabled disabled 0
10 disabled disabled disabled 0
11 disabled disabled disabled 0
12 disabled disabled disabled 0
13 disabled disabled disabled 0
14 disabled disabled disabled 0
15 disabled disabled disabled 0
16 disabled disabled disabled 0
17 disabled disabled disabled 0
18 disabled disabled disabled 0
19 disabled disabled disabled 0
20 disabled disabled disabled 0
21 disabled disabled disabled 0
22 disabled disabled disabled 0
23 disabled disabled disabled 0
24 disabled disabled disabled 0
M24eG#
(1)
(2)
(3)