20
<Command Entry Example>
An example of executing the command to show the system information is shown below.
Fig. 3-1-1 Example of executing the command to show the system information
Terms related to this section are explained below.
(1) Administration Information
Shows the Switching Hub's administration information.
(2) Switch Name
Shows the Switching Hub's current host name.
(3) Switch Location
Shows the Switching Hub's current installation location name.
(4) Switch Contact
Shows the Switching Hub's current contact information.
M24eG> enable
M24eG# show sys-info
System up for : 0 days, 00:00:00
Boot Code Version : xx.xx.xx
Runtime Code version : x.x.x.xx
Hardware Information
Version : Version1
DRAM Size : 32MB
Fixed Baud Rate : 9600bps
Flash Size : 8MB
Administration Information
Switch Name :
Switch Location :
Switch Contact :
System Address Information
MAC Address : xx:xx:xx:xx:xx:xx
IP Address : 0.0.0.0
Subnet Mask : 0.0.0.0
Default Gateway : 0.0.0.0
M24eG#
(1)
(5)
(2)
(3)
(4)