104
Note:
If MAC address auto-learning is disabled, communication cannot be
established unless MAC address is registered statistically.
Note:
Assuming that the number of learned MAC addresses reaches the
limit, and if a frame with new source MAC address that has not been
learned is received, this frame is discarded. To set the limit value,
MAC address auto-learning must be enabled. Static MAC address is
not included in the limit value.
Available commands are listed below.
N Show the next page.
Press "N." The screen shows the next port.
P
Show the previous page.
Press "P." The screen shows the previous port.
S
Switches the status of auto-learning.
Press "S." The command prompt changes to "Select Port Number to be changed>."
Enter a port number you wish to change the setting. Then, the command prompt
changes to "Change MAC Learning Mode for port # (specified port number)>." Press
"A" to enable auto-learning. Press "D" to disable the mode.
L
Set the limit number of MAC address auto-learning.
Press "L." The command prompt changes to "Select Port Number to be changed>."
Enter a port number you wish to change setting. Then, the command prompt
changes to "Enable or Disable MAC Learning Limit status for port # (specified port
number) (E/D)>." Press "E" to set a limit value for the number of auto-learning. Then,
the command prompt changes to "Enter MAC Limit number>." Enter a value of 1 to
256. Press "D" not to set a limit for the number of auto-learning.
Q Return to the previous menu.
