181
Serv Timeout
Displays the timeout for the authentication server.
The factory default setting is 30 seconds.
Re-auth Period
Displays the re-authentication time interval. The factory default
setting is 3600 seconds.
Guest VLAN ID
Displays the VLAN ID to be applied when the terminal is not
authorized. Displays "----" when Guest Access is disabled.
Default VLAN ID
The default VLAN ID is applied when VLAN information could not be
obtained from the authentication server even though the dynamic
VLAN was enabled and succeeded in authentication. Displays "----"
when the Dynamic VLAN is disabled.
Available commands are listed below.
P
Set the port number.
Press "P." The command prompt changes to "Enter port number>." Enter the port
number you wish to configure.
M Set the IEEE802.1X access control type.
Press "M." The command prompt changes to "Select the Port based or MAC based
auth mode (P/M)>." Press "P" for port-based access control or "M" for MAC-based
access control.
C Set the IEEE802.1X access control operation.
Press "C." The command prompt changes to "Select authenticator port
control ?(A/U/F)>." Press "A" for Auto, "U" for Force Unauthorized, or "F" for Force
Authorized.
D Set the transmission/receiving direction of packets to be discarded when the terminal is
not authorized.
Press "D." The command prompt changes to "Select Administrative Control
Direction, Both or In? (B/I)>." Press "B" to control transmission/receiving or "I" to
control receiving.
B Enabled only in MAC-based access control.
T
Set the number of seconds to wait before requesting to reattempt authentication.
Press "T." The command prompt changes to "Enter Transmission Period>." Enter an
integer number between 1 and 65535 (seconds).
U Set the period time to wait before reattempting a failed authentication.
Press "U." The command prompt changes to "Enter quiet period>." Enter an integer
number between 1 and 65535 (seconds).
X Set the maximum number of reattempts of authentication.
Press "M." The command prompt changes to "Enter maximum request count>."
Enter the maximum number of reattempts with an integer between 1 and 10.
O Set the timeout for the authentication server.
Press "O." The command prompt changes to "Enter server timeout>." Enter an
integer number between 1 and 65535 (seconds).
L
Set the timeout for the client.
Press "L." The command prompt changes to "Enter supplicant timeout value>."
Enter an integer number between 1 and 65535 (seconds).
F
Set the VLAN ID of the Default VLAN.
Press "F." The command prompt changes to "Enter default VLAN ID >." Enter the
default VLAN ID of the assignment destination. To disable the function, enter 0.
G Set the VLAN ID of the guest VLAN.
Press "G." The command prompt changes to "Enter guest VLAN ID >." Enter the
guest VLAN ID of the assignment destination. To disable the function, enter 0.
