194
4.7.7.m.1. EAP-Request Port Configuration Menu
On the EAP-Request Configuration, pressing "E" opens the EAP-Request
Port Configuration screen, as shown in Fig. 4-7-25-15. On this screen, you
can configure the EAP Request transmission settings used in the IEEE802.1X
MAC-based access control mode.
Fig. 4-7-25-15 EAP-Request Port Configuration Menu
Screen Description
EAP-Request
Interval
Display the interval (seconds) to transmit EAP-Requests to
unauthorized supplicants.
(Factory default setting: 5 seconds)
Port
Displays the port number.
EAP-Request
Displays the EAP Request transmission status.
Enabled
Transmits EAP Requests to the MAC addresses
registered in the unauthorized MAC address table
at the EAP-Request Interval.
Disabled
Does not transmit EAP Requests. (Factory default
setting)
PN28160i Local Management System
802.1x Access Control Configuration -> EAP-Request Port Configuration
EAP-Request Interval: 5 Sec.
Port EAP-Request
----- ------------
1 Disabled
2 Disabled
3 Disabled
4 Disabled
5 Disabled
6 Disabled
7 Disabled
8 Disabled
-------------------------------- <COMMAND> -----------------------------------
[N]ext Page [E]AP-Request Interval
[P]revious Page [S]et EAP-Request Mode
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option
