98
4.6.7.g. SSH Server Configuration
On the System Security Configuration, pressing "H" opens the SSH Server
Configuration screen, as shown in Fig. 4-6-31. On this screen, you can
configure the SSH server setting. This Switching Hub supports SSHv2 only.
Use and connect a client supporting SSHV2.
Fig. 4-6-31 SSH Server Configuration
Screen Description
SSH UI Idle
Timeout
Shows the idle timeout settings (in minutes) for terminating an SSH
remote-connected session if no input is made.
The factory default setting is 5 minutes.
SSH Auth. Idle
Timeout
Shows the response time to SSH authentication.
The factory default setting is 120 seconds.
SSH Auth.
Retries Time
Shows the number of retries for SSH authentication.
The factory default setting is 5 times.
SSH Server
Shows the SSH access settings.
The factory default setting is "Disabled."
Enabled(SSH)
Access is enabled.
Disabled
Access is disabled.
SSH Server key Shows the status of SSH server key.
Key exists.
The server key exists.
Key does not exist. The server key does not exist.
PN28160i Local Management System
System Security Configuration -> SSH Server Configuration
SSH UI Idle Timeout: 5 Min.
SSH Auth. Idle Timeout: 120 Sec.
SSH Auth. Retries Time: 5
SSH Server: Disabled
SSH Server key: Key does not exist.
-------------------------------- <COMMAND> -----------------------------------
[G]enerate SSH Server key Enable/Disable SS[H] Server
Set SSH UI Time [O]ut Set SSH [A]uthentication Time Out
Set SSH Authentication [R]etries Time [Q]uit to previous menu
Command>
Enter the character in square brackets to select option
