54
Available commands are listed below.
N
Display the next page.
Press "N" to display the next page.
P
Display the previous page.
Press "P" to display the previous page.
S
Configure the MNO series power saving mode for each port.
1. Press "S." The command prompt changes to "Select port number to be changed>." Enter
a port number you wish to configure. (To configure all ports at once, enter "0" as the port
number.)
2. Then, the command prompt changes to "Enter Power Saving mode for port (F/H/D)>."
Press "F" to enable the mode. Press "D" to disable it. Press "H" to select the MNO series
power saving mode that prioritizes connection with other devices.
As the change is applied, the display on the upper screen is updated automatically.
E
Configure the EEE settings for each port.
1. Press "E." The command prompt changes to "Select port number to be changed>." Enter
a port number you wish to configure. (To configure all ports at once, enter "0" as the port
number.)
2. Then, the command prompt changes to "Enable, Disable for Energy Efficient Ether
-
net(EEE 802.3az) (E/D)>." Press "E" to enable the EEE. Press "D" to disable it.
Q
Return to the parent menu.
Mode
Displays the communication speed and full-duplex/half-duplex settings.
For all ports, "Auto" is the factory default setting.
Auto
Auto negotiation mode
100-FDx(100F)
100 Mbps full-duplex
100-HDx(100H)
100 Mbps half-duplex
10-FDx(10F)
10 Mbps full-duplex
10-HDx(10H)
10 Mbps half-duplex
Power-Saving
Displays the status of the MNO series power saving mode.
For all ports, "Half" is the factory default setting.
Half
The MNO series power saving mode status is enabled (Half).
Full
The MNO series power saving mode status is enabled (Full).
Disabled
The MNO series power saving mode status is disabled.
EEE(802.3az)
Displays the EEE (Energy Efficient Ethernet) status.
For all ports, "Enabled" is the factory default setting.
Enabled
The EEE is enabled.
Disabled
The EEE is disabled.
