77
Available commands are listed below.
P
Set the IP address of the SNTP server.
Press "P." The command prompt changes to "Enter new IP address>." Enter the IP address of
the SNTP server.
I
Set the interval time for SNTP synchronization.
Press "I." The command prompt changes to "Enter Interval Time>." Enter the interval of time
synchronization with the SNTP server with a value of 1 to 1440 (minutes).
The factory default setting is 1440 minutes (1 day).
E
Set the application of Daylight Saving (Summer time).
Press "E." The command prompt changes to "Enable or Disable Daylight Saving (E/D)>."
Enter "E" to apply Daylight Saving. Enter "D" not to apply it.
However, in case the set time zone is a zone where Daylight Saving is not applied, this con
-
figuration is not available.
Z
Set the time zone.
Press "Z" to open a list of time zones. Specify a time zone you wish to set.
The factory default setting is "(GMT+09:00) Osaka, Sapporo, Tokyo."
Q
Return to the parent menu.
Note:
In case the SNTP server is located outside of the firewall, connection with the
SNTP server may not be possible depending on settings by the system admin
-
istrator.
For details, ask your system administrator.
If you wish to disable the time synchronization function, set the SNTP server IP
to "0.0.0.0."
