185
Static
Indicates that the terminal was statically authorized
by the registered information.
MAC Control
Displays the authentication type.
Auto
The authentication type is the RADIUS server.
Force
Authorized
The authentication type is force authorized.
Force
Unauthorized
The authentication type is force unauthorized.
Auth Status
Displays the authentication status.
Authorized
Authentication is authorized.
Unauthorized
Authentication is not authorized.
Re-auth
Displays the re-authentication status for each supplicant.
Enabled
Re-authentication is enabled.
Disabled
Re-authentication is disabled.
Available commands are listed below.
P
Set the port number.
Press "P." The command prompt changes to "Enter port number>." Enter the port
number you wish to configure.
M Set the IEEE802.1X access control type.
Press "M." The command prompt changes to "Select the Port based or MAC based
auth mode (P/M)>." Press "P" for port-based access control or "M" for MAC-based
access control.
C Enabled only in port-based access control.
D Set the transmission/receiving direction of packets to be discarded when the terminal is
not authorized.
Press "D." The command prompt changes to "Select Administrative Control
Direction, Both or In? (B/I)>." Press "B" to control transmission/receiving or "I" to
control receiving.
B Set the number of supplicants that can be authenticated.
Press "B." The command prompt changes to "Enter the number of supplicant >."
Enter an integer number between 1 and 512.
T
Set the number of seconds to wait before requesting to reattempt authentication.
Press "T." The command prompt changes to "Enter Transmission Period>." Enter an
integer number between 1 and 65535 (seconds).
U Set the period time to wait before reattempting a failed authentication.
Press "U." The command prompt changes to "Enter quiet period>." Enter an integer
number between 1 and 65535 (seconds).
X Set the maximum number of reattempts of authentication.
Press "M." The command prompt changes to "Enter maximum request count>."
Enter the maximum number of reattempts with an integer between 1 and 10.
O Set the timeout for the authentication server.
Press "O." The command prompt changes to "Enter server timeout>." Enter an
integer number between 1 and 65535 (seconds).
L
Set the timeout for the client.
Press "L." The command prompt changes to "Enter supplicant timeout value>."
Enter an integer number between 1 and 65535 (seconds).
F
Enabled only in port-based access control.
G Enabled only in port-based access control.
E
Set the re-authentication time interval.
