163
4.7. Statistics
On the Main Menu, pressing "S" opens the Statistics Menu screen as shown in Fig.
4-77. On this screen, you can monitor the number of packets as statistics informa
-
tion of the Switching Hub and thereby keep an eye on the network status. In addi
-
tion, monitoring of error packets allows you to segregate failures.
PN28248 Local Management System
Main Menu -> Statistics Menu
Port: 1 Refresh: 300 Sec. Elapsed Time Since System Up: 000:06:28:03
<Counter Name> <Total> <Avg./s>
Total RX Bytes 0 0
Total RX Pkts 0 0
Good Broadcast 0 0
Good Multicast 0 0
CRC/Align Errors 0 0
Undersize Pkts 0 0
Oversize Pkts 0 0
Fragments 0 0
Jabbers 0 0
Collisions 0 0
64-Byte Pkts 0 0
65-127 Pkts 0 0
128-255 Pkts 0 0
256-511 Pkts 0 0
512-1023 Pkts 0 0
Over 1024 Pkts 0 0
-------------------------------- <COMMAND> -----------------------------------
[N]ext [P]revious [S]elect Port Re[f]resh Mode Since [R]eset [Q]uit
Command>
Enter the character in square brackets to select option
Fig. 4-77 Statistics: Values Accumulated after Reboot
Screen Description
Port
Displays the port number.
Refresh
Displays the refresh interval. (The factory default setting is 300 seconds)
Elapsed Time Since
System Up
Displays this Switching Hub's reboot time.
Counter Name
Displays each counter name.
Total
Displays each counter value.
Avg./s
Displays the average value per second of each counter.
Available commands are listed below.
S
Switch the port to display the values.
Press "S." The command prompt changes to "Select Port number>." Enter the port number
for which you wish to display values.
N
Display the values of the next port.
Press "N." The screen displays the counter values of the next port. The command is invalid
for Port 18.
P
Display the values of the previous port.
Press "P." The screen displays the counter values of the previous port. The command is
invalid for Port 1.
