57
Available commands are listed below.
C
Configure the idle timeout settings for automatically terminating a console-connected session if
no input is made.
Press "C." The command prompt changes to "Enter console idle timeout>." Enter a value
from 0 to 60 (minutes). Entering "0" disables the automatic termination.
T
Configure the idle timeout settings for automatically terminating a Telnet-connected session if
no input is made.
Press "T." The command prompt changes to "Enter telnet idle timeout>." Enter a value from
1 to 60 (minutes).
L
Configure the Telnet access settings.
Press "L." The command prompt changes to "Enable or Disable telnet server(E/D)>." Enter "E"
to enable the access. Enter "D" to disable it.
W Configure the Web browser access settings.
Press "W." The command prompt changes to "Enable or Disable web server (E/D)>." Enter
"E" to enable the access. Enter "D" to disable it.
B
Configure the LED base mode settings.
Press "B" to move to the LED Basic Mode Configuration page. For configuration details,
refer to the next section (4.5.7.e).
R
Configure the settings to access the RADIUS server. The RADIUS is used in the IEEE802.1X
authentication.
Press "R" to move to the RADIUS Configuration page. For configuration details, refer to the
next section (4.5.7.b).
Y
Configure the settings for sending system logs to the Syslog server.
Press "Y." The command prompt changes to "Enable or Disable Syslog Transmission (E/D)>."
Enter "E" to enable the Syslog transmission to the Syslog server. Enter "D" to disable it.
N
Edit the login username.
1. Press "N." The command prompt changes to "Enter current password>." Enter the cur
-
rent password.
2. After entering the correct password, the command prompt changes to "Enter new
name>." Enter a new username in 12 characters.
P
Edit the login password.
1. Press "P." The command prompt changes to "Enter old password>." Enter the current
password.
2. If the password is correct, the command prompt changes to "Enter new password>."
Enter a new password in 12 characters.
3. After entering the password, the command prompt changes to "Retype new password>"
for confirmation. Enter the new password again.
S
Configure the SNMP access settings.
Press "S." The command prompt changes to "Enable or Disable SNMP Agent(E/D)>." Enter
"E" to enable the access. Enter "D" to disable it.
I
Configure the access settings for the IP address configuration software, bundled with the Pana
-
sonic network cameras.
Press "I." The command prompt changes to "Enable or Disable IP setup interface (E/D)>."
Enter "E" to enable the access. Enter "D" to disable it.
A
Configure a terminal accessible via Telnet.
Press "A" to move to the Telnet Access Limitation Menu. For configuration details, refer to
the next section (4.5.7.a).
G
Configure the settings for sending system logs to the Syslog server.
Press "G" to move to the Syslog Transmission Configuration page. For configuration details,
refer to the next section (4.5.7.c).
