43
4.5.3.b.
SNMP Trap Receiver Configuration
On the SNMP Configuration Menu, pressing "T" opens the SNMP Trap Receiver
Configuration Menu screen, as shown in Fig. 4-12. On this screen, you can config
-
ure the SNMP Trap settings.
PN28248 Local Management System
SNMP Configuration -> SNMP Trap Receiver Configuration Menu
Trap Receiver List:
No. Status Type IP Address Community
---- -------- ----- --------------- ----------------------------
1 Disabled v1 0.0.0.0
2 Disabled v1 0.0.0.0
3 Disabled v1 0.0.0.0
4 Disabled v1 0.0.0.0
5 Disabled v1 0.0.0.0
6 Disabled v1 0.0.0.0
7 Disabled v1 0.0.0.0
8 Disabled v1 0.0.0.0
9 Disabled v1 0.0.0.0
10 Disabled v1 0.0.0.0
-------------------------------- <COMMAND> -----------------------------------
Set Receiver [S]tatus Set Receiver [I]P In[d]ividual Trap Config
Set Trap [T]ype Set Receiver [C]ommunity [Q]uit to previous menu
Command>
Enter the character in square brackets to select option
Fig. 4-12 SNMP Trap Receiver Configuration
Screen Description
Trap Receiver List: Displays the IP addresses and the community names for the current trap
receivers.
No.
Displays the entry number for the trap receiver.
Status
Displays the trap sending setting.
Enabled
Sends traps.
Disabled
Does not send traps.
Type
Displays the type of traps.
V1
Sends traps of SNMP v1.
V2
Sends traps of SNMP v2.
IP Address
Displays the IP address of the trap receiver.
Community
Displays the current community name, set for sending
traps.
