63
4.5.7.c.
Syslog Transmission Configuration
On the System Security Configuration Menu, pressing "G" opens the Syslog Trans
-
mission Configuration Page screen, as shown in Fig. 4-20. On this screen, you can
configure the settings of the Syslog server to which a system log is sent.
PN28248 Local Management System
System Security Configuration -> Syslog Transmission Configuration Menu
Syslog Server List:
No. Status IP Address Facility Include SysName/IP
---- ----------- --------------- ---------- ------------------
1 Disabled 0.0.0.0 Facility0
2 Disabled 0.0.0.0 Facility0
-------------------------------- <COMMAND> -----------------------------------
Set Server [S]tatus Set Server [I]P [Q]uit to previous menu
Set Server [F]acility Set S[y]sName/IP Include [C]lear Server Information
Command>
Enter the character in square brackets to select option
Fig. 4-20 Syslog Transmission Configuration
Screen Description
Status
Displays the status of each entry.
Enabled
Setting of the entry is enabled.
Disabled
Setting of the entry is disabled.
IP Address
Displays the IP address of the Syslog server.
Facility
Displays the value of Facility.
Include Sys
-
Name/IP
Displays information to be added.
SysName
Adds the SysName of this Switching Hub to the system log to be
transmitted.
IP address
Adds the IP address of this Switching Hub to the system log to
be transmitted.
Available commands are listed below.
S
Set the status of Syslog Transmission.
1. Press "S." The command prompt changes to "Enter manager entry number>." Enter a num
-
ber you wish to set.
2. Then, the command prompt changes to "Enable or Disable Server (E/D)>." Enter "E" to
enable the server. Enter "D" to disable it.
