65
4.5.7.d.
SSH Server Configuration
On the System Security Configuration Menu, pressing "H" opens the SSH Server
Configuration screen, as shown in Fig. 4-21. On this screen, you can configure the
SSH server settings.
This Switching Hub only supports SSHv2. Use a client that supports SSHv2 and
connect to it.
PN28248 Local Management System
Basic Switch Configuration -> SSH Server Configuration
SSH UI Idle Timeout: 5 Min.
SSH Auth. Idle Timeout: 120 Sec.
SSH Auth. Retries Time: 5
SSH Server: Disabled
SSH Server key: Key exists.
-------------------------------- <COMMAND> -----------------------------------
[G]enerate SSH Server key Enable/Disable SS[H] Server
Set SSH UI Time [O]ut Set SSH [A]uthentication Time Out
Set SSH Authentication [R]etries Time [Q]uit to previous menu
Command>
Enter the character in square brackets to select option
Fig. 4-21 SSH Server Configuration
Screen Description
SSH UI Idle Timeout:
Displays the idle timeout settings (in minutes) for terminating a SSH-
connected session if no input is made.
The factory default setting is 5 minutes.
SSH Auth. Idle Timeout:
Displays the time to wait for a response to SSH authentication.
The factory default setting is 120 seconds.
SSH Auth. Retries Time:
Displays the number of times of retransmission of SSH authentication.
The factory default setting is 5.
SSH Server:
Displays the SSH access settings.
"Disabled" is the factory default setting.
Enabled(SSH)
Access is enabled.
Disabled
Access is disabled.
SSH Server key:
Displays the SSH server key status.
Key exists.
The server key exists.
Key does not exist.
The server key does not exist.
