67
4.5.7.e.
LED Base Mode Configuration
On the System Security Configuration Menu, pressing "B" opens the LED Base
Mode Configuration screen, as shown in Fig. 4-22. On this screen, you can config
-
ure the LED base mode settings.
PN28248 Local Management System
System Security Configuration -> LED Base Mode Configuration
LED Base Mode: Status
Note: Save Configuration to Flash will be executed when LED Base Mode changed.
-------------------------------- <COMMAND> -----------------------------------
Set LED [B]ase Mode
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option
Fig. 4-22 LED Base Mode Configuration
Screen Description
LED basemode
Displays the current LED base mode.
For all ports, the factory default setting is set to the Status mode (Status).
Status
Operating in the Status mode.
Eco
Operating in the ECO mode.
Available commands are listed below.
B
Change the current LED base mode.
Press "B." The command prompt changes to "Select LED Base Mode (S/E)>." Press "S" to
change the LED base mode to the Status mode. Press "E" to change to the ECO mode.
Q
Return to the parent menu.
Note:
When you change the LED base mode, all configuration information will be
saved into the internal memory.
