Product Outline
1.1 Features
1
Has wire-speed Layer 3 switching function.
Ports 1 to 24 are 10BASE-T/100BASE-TX/1000BASE-T ports corresponding to
autonegotiation.
Also their speed and communication mode can be switched by configuration.
Ports 21 to 24 are SFP extension slots.
These ports and the 1000BASE-T twisted pair cable ports cannot be used
simultaneously.
Ports 25 to 28 are SFP+ extension slots. They are capable of 10-Gbps
communications. They can be used as SFP or SFP+ ports.
Settings and firmware can be changed and saved by using an SD card.
All twisted pair ports support straight/cross cable auto sensing function. Simply
connect devices with straight cables, whether it is a terminal or a network device.
(This function does not work if the port communication configuration is set at Fixed
or Link Aggregation.)
Embedded power saving mode detects the connection status automatically and
saves power consumption to minimum.
If the stacking functions have been activated, ports 29 and 30 will be stacking ports.
By using the 40G direct attach cables, stacking connections are feasible for up to a
maximum of four units whereas the ZEQUO 6700RE, or the ZEQUO 6600RE are mixed.
7
The ZEQUO 6600RE is a Layer 3 all giga Ethernet Switch equipped with management
functions that has 24 10/100/1000BASE-T ports, 4 SFP expansion ports, 4 SFP+ expansion
ports and 2 40G stack ports.
The ports which generated the loops give notification via LEDs, and the ports which
generated the loops are automatically shut off via the loop detection and blocking functions.
The ports which generated the loops are displayed via LEDs, and the network manager
can identify the ports which generated the loops after the loop resolution via the loop
history functions.
Triple authentication which can simultaneously wait for IEEE802.1X, MAC, and WEB
authentications at a single port is supported, and an authentication network can be
configured which matches the kinds of connection terminals.
Step authenticating is supported, and user authentications and terminal authentications
can be implemented in phases.
A power supply redundancy can be configured via the additional purchases and mounting
of power modules.
The power modules and fan modules are hot-swappable.
The Ring Redundant Protocol (RRP) is supported, allowing to make a redundant net-work
-
via ring topology.
