5
English
■
About wired LAN
Take sufficient shielding measures at a location where static electricity tends to be generated before using
the product.
When using the product at locations where lots of static electricity is generated such as carpet, wired LAN
communication tends to be disconnected. In this case, use an antistatic mat, etc. to eliminate the problematic static
electricity and noise source from the area surrounding this product and cables.
On rare occasions, LAN connection may not be established due to static electricity or noises. In this case, turn off
the power of the product and devices connected to this product once, and then turn on the power of them again.
When there is equipment that generates strong radio waves in the vicinity, install the product sufficiently away from
such equipment.
■
Cleaning and maintenance
First, remove the mains plug from the mains socket.
Gently wipe the surface of the case by using a soft cloth to remove dirt.
•To remove stubborn dirt or fingerprints, dampen a cloth with diluted neutral detergent (1 part detergent to 100 parts
water), wring out the cloth firmly, and then wipe away the dirt. Finally, wipe away all the moisture with a dry cloth.
•If water droplets get inside the unit, operating problems may result.
Usage of a chemical cloth
•Follow the instructions for the chemical cloth.
Avoid contact with volatile substances such as insect sprays, solvents and thinner.
•This may cause damage to the case or cause peeling of the paint. Furthermore, do not leave it in contact with a
rubber or PVC substance for a long time.
Note when using alcohol
•Soak a small amount of alcohol at a concentration of 60 % or less in a soft cloth and wipe the housing. Then be
sure to use a dry cloth to wipe it.
Note that wiping the housing with a hard cloth or rubbing it strongly may cause damage. Also, do not allow water
droplets to enter the inside to prevent malfunction. Do not directly spray alcohol.
•Do not use antiseptic solutions other than alcohol.
■
Disposal
When disposing the product, ask your local authority or dealer about the correct methods of disposal.
